DataProtection Solutions by Arco

Call toll free 1-800-458-1666

Duplidisk3 Firmware Upgrade v3.37

This firmware supports an option to connect two additional Slave drives (configured as Slaves) to the Primary and Mirror channels of the DupliDisk3. It doesn't support Slave device connected to the same IDE cable connected to the Host side of the DupliDisk3.

Installation Instructions

If you have a DOS boot diskette, unzip dd3_337_309_up.zip onto your bootable diskette. Also, download and copy “Duplidisk DOS Utility” to your DOS boot diskette from http://arcoide.com/support_downloads.php
If you do not have a DOS boot diskette, create a DOS boot diskette from the CD provided with the Duplidisk. If you do not have the CD, download "Duplidisk DOS Boot Disk Maker for Windows" from http://arcoide.com/support_downloads.php. Remove all ACP.* files from the bootable diskette and unzip dd3_337_309_up.zip onto the bootable diskette. Note: Here are the individual files details included in this upgrade: Code337.hex - (Upgrade Code) Data309.hex – (Upgrade Data) Dupli337.txt - (Pointer File)
FLASH INSTRUCTIONS! PLEASE READ CAREFULLY! This Duplidisk 3 firmware upgrade must be done by following the directions in the order detailed below:
- Reboot the PC from the DOS diskette and select Duplidisk 2 and 3 support utility software.
- In the Configure dropdown menu select FIRMWARE UPGRADE.
- Select Dupli337.txt. After the upgrade is completed, remove the diskette and power cycle your computer.
- The firmware upgrade is completed you can now resume normal operation.